BILL CHANGER 

Installation Guide 

Model: BC500 

BILL CHANGER ASSEMBLY 

1. Specifications: 

(1) Dimension: (H) 24 ¾" (W) 7 1/8" (D) 11 ½"

     Shipping Dimensions: (H) 30" (W) 13" (D) 17"

(2) Weight: Empty 39 lbs.  Shipping Weight: 42 lbs.

(3) Power Requirement: AC 115v  60Hz

(4) Operating Temperature: 48°F to 120°F

(5) Operating Humidity: 30% to 85% RH

(6) Installation Location: Indoor

(7) Coin Capacity: Approx. 750 coins

(8) Counting Method: Two Optical Sensor

2. Panel: 

3. Subassembly: 

COIN BOX 

4. Fill Coin Box To A Level Higher Than The Sensors. 

BILL ACCEPTOR 

5. Bill Acceptor LED Display: 

The two LED lights located at the front of the unit will show the operational status of the bill validator.  The LED lights will flash ON and OFF (in 500ms intervals) when the unit is ready to accept bills.  The LED lights will be OFF if the unit is disabled or out of service, in which case the unit will not accept any bills.

The bill validator can only accept one bill at a time.  The LED lights will be OFF and will not accept another bill while a bill is being validated in the unit.  The LED lights will start to flash normally when the bill validator is ready to accept the next bill.

6. LED Status: 

COIN COUNTER 

7. Specifications: 

(1) Weight: Approx. 26oz.

(2) Power: DC+12V

(3) Environment Range 

     Operating temperature: 32°F to 104°F 

     Storage temperature: -8°F to 116°F 

(4) Function 1:

     Press and hold the reset key for 3 seconds to reset the counter back to "0".

Function 2:

If more then 4 digits are stored on the counter, press the reset key to display the next digits.

BILL CHANGER 

8. Trouble Shooting Table 

PARTS ORDERING 

Procedure:

When ordering parts, include the following:

(1) The model and serial numbers of the machine for which the parts are needed.

(2) Shipping address

(3) Address where the invoice should be sent

(4) The number of parts required.

(5) Always refer to the pertinent parts and/or part manual for the correct part number and description of a specific part.

Note: When RIGHT or LEFT is used with the name of a part, it means the person is facing the machine with the door closed.

(6) Any special shipping instructions.

(7) Carrier desired: air or air special, truck, parcel post or rail.

(8) Signature and date.

(9) Purchase order number, if used.

Mail your order to:

VendNet™ 

P.O. Box 488 

165 North 10^th Street 

Waukee, IA 50263-0488 USA 

All orders are carefully packed and inspected prior to shipment.  Damage incurred during shipment should be reported at once and a claim filed with the terminating carrier.  If you do not have the right parts manual: contact VendNet™.  If you have any questions, call:    

Service: 1-888-VENDNET (836-3638)

Parts: 888-259-9965

Fax: 515-274-5775

Email: techsupport@vendnetusa.com

Web: www.vendnetusa.com